You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice.

Credit subject to status, UK residents only, Axminster Tool Centre Ltd trading as Axminster Tools acts as a broker and offers finance from a restricted range of finance providers, PayPal Credit is a trading name of PayPal UK Ltd, Whittaker House, Whittaker Avenue, Richmond-Upon-Thames, Surrey, United Kingdom, TW9 1EH.Credit is provided by Novuna Personal Finance, a trading style of Mitsubishi HC Capital UK PLC, authorised and regulated by the Financial Conduct Authority. Our machinery range includes, lathes, bandsaws, table saws, spindle moulders, planers and thicknessers and pillar drills as well as dust extractors, welders and water pumps. To ensure accurate fitment and smooth movement of timber, the table extension features fine-adjustment mechanisms to allow the extension to be fitted perfectly flush to the table. It can be fitted either to the rear or the right-hand side of the main table, to give support where it is needed most.

I did have two problems with it, one of which would have been difficult if not impossible to remedy in advance. Instead of threaded holes in the table to bolt into I had to drill through the flange to use four 5/16″ nuts and bolts to secure the fence with. Thanks Randy, this is just the advice I needed to read - and wanted to read tbh - as I'm enamored of the idea. Hi Paul, I may be able to make use of one of the fences that you’re not a fan of; I’ve used similar and found it fine for what I do, and would certainly be better that the fence that’s currently on my old Startrite (sadly not the same design as you’re old Startrite fence). Mine came with a slightly different aluminium fence profile than the one shown in the pictures above (It looks like the one on the Laguna picture).I have cut veneer-thin to 3/16″ pieces 10″ tall too and they have been very accurate cuts ready for scraping or sanding. You want the hole for the bolt to be far enough away from the fence that you can get a hand drill in there. Hi Paul, I upgraded my Rigid bandsaw with the Kregg fence some time back and have since added the micro adjuster. There’s always just a little bit of "drift" that prevents you from getting precise cuts even when you are using a fence.

People do different things with their bandsaws and make them do things that they were not meant to do and for a wide range of reasons, not the least of which can be laziness and being unskilled in other areas like using hand tools.Despite these humble origins, this bandsaw fence is rock-solid, operates smooth as silk, adjusts for drift, and offers up to 9 in. Once I had had the table modified by adding a flat bar to the front edge, deep enough to allow for the fixing, all was well. Let the glue dry, then drill through the hinge block and into the runner to create a pilot hole for the threaded insert that will hold the pivot bolt. This fence mounts to most 14" (356mm) band saws right out of the box and can be modified to fit many others by drilling a single hole in the aluminum mounting rail.