Clean all tools and application equipment with Sika Remover 208 or Thinner EG immediately after use. Hardened / cured material can only be mechanically removed. The laying instructions of the wood floor manufacturer as well as standard construction rule must be observerd.

Fresh, uncured adhesive remaining on the wood floor surface must be removed immediately with a clean cloth and if necessary cleaned with Sika Remover 208. Test wood floor surfaces for compatibility with Sika Remover 208 before use. The laying instructions of the wood floor manufacturer as well as standard construction rules must be observed. SikaBond 5500S can be used without priming on cement floors, poured asphalt and wooden floor panel providing they are dust free and permanently dry. Information For information and advice on the safe handling, storage and disposal of chemical products, users shall refer to the most recent Material Safety Data Sheet containing physical, ecological, toxicological and other safety-related data.If, according to wood floor suppliers or producers deviation from the standards is permissible, temperatures between 5°C and 35°C must be observed for the adhesive. Sika SikaBond 5500S is a single part combination of synthetic resins contained in organic solvents. anhydrite screed/anhydrdite flowable screed: must be ground and thoroughly cleaned with industrial vacuum cleaner and primed with Sika Primer MB or SikaBond 5500S diluted 1:1 with thinner EG; To find Ready Mixed colours, search "ready mixed" or select the Ready Mixed 'colour chart'. To see Tinted colours select a colour chart such as RAL, BS, NCS, etc. or search for a colour/hue to see available or related options. All technical data stated in this Product Data Sheet are based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.

Anhydrite screed / Anhydrite flowable screed: Must be ground and thoroughly cleaned with industrial vacuum cleaner.The substrate must be clean and dry, homogeneous, even, free from grease, dust and loose particles. Paint, cement laitance and other poorly adhering particles must be removed. Standard construction rules must be observed. Underfloor Heating: After thorough preparation and commissioning of the heating system, the entire floor area must be primed using a mixture of 1 part SikaBond 5500 S to 1 part Sika Thinner EG (by Volume). Roller apply and allow to cure. The product and its vapours are highly inflammable, ensure adequate air ventilation during application and curing.

Clean and dry, homogeneous, even, free from grease, dust and loose particles. Paint, cement laitance and other poorly adhering particles must be removed. Standard construction rules must be observed. Concrete / cement screed: Must be clean, dry, contaminant free and thoroughly cleaned with industrial vacuum cleaner. In case of chemically pre-treated types of wood floors (e.g. ammonia, wood stain, timber preservative) and woods with high oil content SikaBond 5500 S is only to be used after a written recommendation following trials from our Technical Department. Substrate Quality: Clean and dry, homogeneous, even, free from grease, dust and loose particles. Paint, cement laitance and other poorly adhering particles must be removed. Standard construction rules must be observed. Concrete / cement screed:Must be clean, dry, contaminant free and thoroughly cleaned with industrial vacuum cleaner.full surface bonding with SikaBond® Dispenser-5400 / -3600 / -1800: solid and engineered wood floors (strips, longstrips, planks, panels, boards), mosaic parquet, industrial parquet, lam parquet as well as chip boards can all be bonded; Avoid getting adhesive on the side of the wood elelemns. Fresh, uncured adhesive remaining on the wood floor surface must be removed immediately with a clean cloth and if necessary cleaned with Sika Remover -208. Test wood floor surfaces for compatibility with Sika Cleaner 208 before use.