Ner Nstrike Elite Rapidstrike CS18

Product Information

As far as differences go, there are plenty to choose from! For example, the two blasters vary greatly in firing range. The Hyperstrike has a 15 foot lead over the Rapidstrike and it even fires at a faster rate of 5 darts per second rather than the Rapidstrikes’ 3 darts per second. Keep collections to yourself or inspire other shoppers! Keep in mind that anyone can view public collections - they may also appear in recommendations and other places. In fact, there are not very many similarities between these two blasters, other than both being motorized blasters from the Elite line.

It features five tactical rails: one on the carrying handle, one on top, one underneath, and one on each side of the blaster. There are four strap points: one on the end of the handle, two on the end of the tactical rail, and one above the muzzle. Like the Nerf Hyperfire the Rapidstrike was released to N-Strike Elite series. Slightly older than the Hyperfire having been released in 2013, the Rapidstrike is still a motorized blaster powered by several batteries.

Was the pusher box installed? If it is not, the cycle control switch will remain up indefinitely, causing this symptom. In this guide, we are building a "front-wired" RS. In "front wiring", the battery leads exit the rest of the harness at the flywheel cage area. The only difference is how the flywheel cage's negative connection is handled and where the battery leads go. Phillips screwdriver of any size that will not slip on external RS screws and fits into all counterbores on exterior of gun The RapidStrike is commonly modified to be smaller and "minimized" through the removal of most of the front half of the blaster.

Full-size microswitch with roller-lever or simulated roller actuator, 10A rated or higher, to fit FCG and grip internals (optional, but recommended) The barrel of the blaster is notably rifled, similar to the Retaliator barrel extension. It features compatibility with barrel extensions; due to the barrel extension connector being a separate piece of plastic from the main barrel, it can loosen up, resulting in loose fitted barrel extension. It is incompatible with the LongStrike barrel extension, due to inner barrel supports.I have the same results with 2 and 3 cell zippys (6.6 and 9.9v) and the behavior is the same (I have a 7.4V batt on the way).